Rear power sunshade (if so equipped)
Console lightCamshaft Valve Clearance
Valve Clearance
CHECKING
NOTE:
Perform inspection as follows after removal, installation or
replacement of camshaft or valve related parts, or if there are unusual
engine conditions regarding valve clearance.
Check valve clearance while engine is cold and not running.
Remove th ...
Front fog lamp circuit
Description
The IPDM E/R (intelligent power distribution module engine room) controls the
front fog lamp relay based on inputs from the BCM over the CAN communication
lines. When the front fog lamp relay is energized, power flows from the front
fog lamp relay in the IPDM E/R to the front fog ...
P0447 evap canister vent control valve
Description
The EVAP canister vent control valve is located on the EVAP canister
and is used to seal the canister vent.
This solenoid valve responds to signals from the ECM. When the
ECM sends an ON signal, the coil in the solenoid valve is energized.
A plunger will then move to seal ...