Nissan Maxima Service and Repair Manual: Symptom diagnosis

Instrument panel

...

Squeak and rattle trouble diagnoses

Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the ...

Other materials:

Antenna AMP
Removal and Installation REMOVAL Remove the rear pillar finisher RH. Refer to INT-23, "Exploded View". Detach the antenna amp. harness clip (A). Disconnect the harness connectors (B) from the antenna amp. (1). Remove the antenna amp. screw (C) and the antenna amp. (1). INSTALLAT ...

P0703 brake switch B
Description BCM detects ON/OFF state of the stop lamp switch and transmits the data to the TCM via CAN communication by converting the data to a signal. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: Immediately after perform ...

System maintenance
The sensor for the ICC system A is located on the front of the vehicle. To keep the ICC system operating properly, be sure to observe the following: Always keep the sensor area clean. Do not strike or damage the areas around the sensor. Do not touch or remove the screw located on ...