Precaution
PreparationB2562 Low voltage
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1. DTC CONFIRMATION
Erase DTC.
Turn ignition switch OFF.
Perform the "SELF-DIAG RESULTS" of BCM with CONSULT, after the
ignition switch has been turned ON
for 1.5 seconds or more.
Diagnosis Procedure
1. CHECK ...
The fuel gauge pointer does not move to "F" when refueling
Description
The fuel gauge needle will not move to "F" position when
refueling.
Diagnosis Procedure
1.OBSERVE FUEL GAUGE
Does it take a long time for the pointer to move to FULL
position?
2.IDENTIFY FUELING CONDITION
Was the vehicle fueled with the ignition switch ON?
3.OBSERVE VEHICLE PO ...
Power steering
WARNING
If the engine is not running or is turned
off while driving, the power assist for
the steering will not work. Steering will
be harder to operate.
When the power steering warning light
illuminates with the engine running,
there will be no power assist for the
steering. You w ...