Nissan Maxima Service and Repair Manual: Automatic drive positioner control unit

Removal and installation

...

Seat memory switch

Removal and Installation REMOVAL Remove the seat memory finisher using a suitable tool (1). Refer to INT-18, "Removal and Installation". Release the pawls and remove seat memory switch (2) f ...

Other materials:

P0451 evap control system pressure sensor
Description The EVAP control system pressure sensor detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: Never remove fuel filler cap during DTC confirmation procedur ...

Combination meter
Reference Value VALUES ON THE DIAGNOSIS TOOL NOTE: * The monitor will indicate "OFF" even though the brake warning lamp is on if either of the following conditions exist: The parking brake is engaged The brake fluid level is low TERMINAL LAYOUT PHYSICAL VALUES ...

Front tweeter
Removal and Installation REMOVAL Remove the front pillar finisher. Refer to IP-10, "Exploded View". Remove the front tweeter speaker grille. Refer to IP-10, "Exploded View". Remove the front tweeter speaker screws (A). Pull out front tweeter speaker (1), disconnect the harness con ...