Nissan Maxima Service and Repair Manual: Removal and installation

Precaution

PRECAUTIONS Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used alo ...

Automatic drive positioner control unit

Removal and Installation REMOVAL Remove audio unit. Refer to AV-73, "Removal and Installation" (BASE AUDIO), AV-161, "Removal and Installation" (BOSE W/MONOCHROME DISPLAY), AV-481, "Removal ...

Other materials:

P0840 transmission fluid pressure SEN/SW A
The secondary pressure sensor detects secondary pressure of CVT and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds b ...

IPDM E/R (intelligent power distribution module engine room)
Reference Value VALUES ON THE DIAGNOSIS TOOL TERMINAL LAYOUT PHYSICAL VALUES Fail Safe CAN COMMUNICATION CONTROL When CAN communication with ECM and BCM is impossible, IPDM E/R performs fail-safe control. After CAN communication recovers normally, it also returns to nor ...

P0327, P0328, P0332, P0333 KS
Description The knock sensor is attached to the cylinder block. It senses engine knocking using a piezoelectric element. A knocking vibration from the cylinder block is sensed as vibrational pressure. This pressure is converted into a voltage signal and sent to the ECM. DTC Logic DTC DETE ...