Nissan Maxima Service and Repair Manual: Tilt&telescopic switch
Removal and Installation
REMOVAL
- Remove the steering column side cover (LH) (1). Refer to IP-13, "Removal and Installation".
- Release the pawls and remove tilt & telescopic switch (2) from the steering column side cover (LH) (1).
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Be sure to install the harness in the right place.
Seat memory switch
Removal and Installation
REMOVAL
Remove the seat memory finisher using a suitable tool (1). Refer
to INT-18, "Removal and Installation".
Release the pawls and remove seat memory switch (2) f ...
Other materials:
P0605 ECM
Description
The ECM consists of a microcomputer and connectors for signal
input and output and for power supply. The ECM controls the engine
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always ...
BCM (body control module)
Reference Value
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the
following functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS transmitter IDs
Display tire pressure reported by the TPMS transmitter
Read TPMS DTCs
R ...
P1574 ASCD vehicle speed sensor
Description
The ECM receives two vehicle speed signals via the CAN communication line.
One is sent from combination
meter, and the other is from TCM (Transmission control module). The ECM uses
these signals for ASCD control.
Refer to EC-68, "System Diagram" for ASCD functions.
D ...
Nissan Maxima Owners Manual
- Illustrated table of contents
- Safety-Seats, seat belts and supplemental restraint system
- Instruments and controls
- Pre-driving checks and adjustments
- Monitor, climate, audio, phone and voice recognition systems
- Starting and driving
- In case of emergency
- Appearance and care
- Do-it-yourself
- Maintenance and schedules
- Technical and consumer information
Nissan Maxima Service and Repair Manual
0.0093