Verify the location of all Intelligent Keys that are programmed for the vehicle. If another Intelligent Key is in range or inside the vehicle, the vehicle system may respond differently than expected.
|
Symptom |
Possible Cause | Remedy | |
| When pushing the ignition switch to stop the engine | The red "Shift to Park" warning appears on the vehicle information display and the inside warning chime sounds continuously. | The shift lever is not in the P (Park) position. | Move the shift lever to the P (Park) position |
| When shifting the shift lever to the P (Park) position | The Push ignition to OFF warning appears in the display. | The ignition switch is in the ACC position. | Place the ignition switch in the OFF position. |
| When opening the driver's door to get out of the vehicle | The door open warning appears on the display and the inside warning chime sounds continuously. | The ignition switch is in the ACC position. | Place the ignition switch in the ON position or close the driver's door. |
| When closing the door after getting out of the vehicle | The yellow "No Key Detected" warning appears on the vehicle information display, the outside chime sounds three times and the inside warning chime sounds for approximately three seconds. | The Intelligent Key is not detected inside of the vehicle. | Place the ignition switch in the OFF position. |
| The red "Shift to Park" warning appears on the vehicle information display and the inside and outside chimes sound continuously. | The ignition switch is in the ACC or OFF position and the shift lever is not in the P (Park) position. | Carry the Intelligent Key with you. | |
| When closing the door with the inside lock knob turned to LOCK | The outside chime sounds for approximately three seconds and all the doors unlock. | The Intelligent Key is inside the vehicle. | Carry the Intelligent Key with you. |
| When pushing the door handle request switch or the LOCK button on the Intelligent Key to lock the door | The outside chime sounds for approximately three seconds. | The Intelligent Key is inside the vehicle. | Carry the Intelligent Key with you. |
| When pushing the ignition switch to start the engine | The Intelligent Key battery indicator appears on the display. | The battery charge is low. | Replace the battery with a new one. For additional information, refer to "Battery replacement" in the "Maintenance and do-ityourself" section of this manual. |
| The yellow "Key ID Incorrect" warning appears on the vehicle information display. | The Intelligent Key is not detected inside of the vehicle. | Carry the registered Intelligent Key with you. | |
| When closing the trunk lid | The outside chime sounds for approximately 10 seconds and the trunk lid opens. | The Intelligent Key is inside the trunk. | Carry the Intelligent Key with you. |
Warning signals
Remote Engine StartU1000 CAN comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent malfunction
detection ability.
Many electronic control units are equipped onto a vehicle, an ...
Power supply and ground circuit
BCM
BCM : Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuses or fusible link are blown.
2. CHECK POWER SUPPLY CIRCUIT
Turn ignition switch OFF.
Disconnect BCM.
Check voltage between BCM harness connector and ground.
3. CHECK GROUND CIRCUIT
Che ...
Air breather hose
Exploded View
Air cleaner case
Air breather hose
Transaxle assembly
Heater pipe
Clip
A. Paint mark
: Front
Removal and Installation
REMOVAL
Remove front air duct. Refer to EM-24, "Removal
and Installa ...