Nissan Maxima Service and Repair Manual: Combination meter display function

Horn function

Description Perform answer-back for each operation with horn. Component Function Check 1. CHECK FUNCTION Select HORN in "ACTIVE TEST" mode with CONSULT. Check the horn (high/low) operation. ...

Warning chime function

Description Performs operation method guide and warning with buzzer. Component Function Check 1. CHECK FUNCTION With CONSULT Check the operation with "INSIDE BUZZER" in the Active Test. To ...

Other materials:

P0451 evap control system pressure sensor
Description The EVAP control system pressure sensor detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: Never remove fuel filler cap during DTC confirmation procedur ...

System maintenance
The two radar sensors 1 for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused b ...

Passenger compartment
WARNING Never use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or electronic control units or cause a fire. If any electrical equipment does not operate, check for an open fuse. 1. Be sure the ignition switch ...