Nissan Maxima Service and Repair Manual: ECU diagnosis information

Door switch

Description Detects door open/close condition. Component Function Check 1.CHECK FUNCTION With CONSULT Check door switches DOOR SW-DR, DOOR SW-AS in Data Monitor mode with CONSULT. Diagnosis Pr ...

BCM (body control module)

Reference Value NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display ...

Other materials:

The oil pressure warning lamp does not turn on
Description The oil pressure warning lamp stays off when the ignition switch is turned ON. Diagnosis Procedure 1.CHECK OIL PRESSURE WARNING LAMP Perform IPDM E/R auto active test. Refer to PCS-11, "Diagnosis Description". 2.CHECK OIL PRESSURE SWITCH SIGNAL CIRCUIT Check the oil pressure sw ...

Removal and installation
BCM (BODY CONTROL MODULE) Removal and Installation For removal and installation of the BCM. PUSH BUTTON IGNITION SWITCH Removal and Installation REMOVAL Remove push-button ignition switch from cluster lid A using a suitable tool. Disconnect harness connector from push-button ignition s ...

P0840 transmission fluid pressure SEN/SW A
The secondary pressure sensor detects secondary pressure of CVT and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds b ...