Nissan Maxima Service and Repair Manual: Basic inspection

Removal and installation
SUNROOF UNIT ASSEMBLY Inspection WIND DEFLECTOR Open glass lid assembly fully. Visually check for proper installation, damaged/deteriorated components, or foreign objects within mechanism ...

Diagnosis and repair workflow
WorkFlow DETAILED FLOW 1.OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain the malfunction information (conditions and environment when the malfunction occurred) as much as possib ...

Other materials:

Vehicle Dynamic Control (VDC) off switch
The vehicle should be driven with the VDC system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The engine speed will be reduced even if the accelerator is depressed to the floor. If maximum engine po ...

System maintenance
The two radar sensors 1 for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused b ...

System maintenance
The sensor A is located behind the lower grille of the front bumper. To keep the system operating properly, be sure to observe the following: Always keep the sensor area of the front bumper clean. Do not strike or damage the areas around the sensor. Do not cover or attach sticke ...

Nissan Maxima Owners Manual

Nissan Maxima Service and Repair Manual

© 2017-2026 Copyright www.nimainfo.com
0.0075