Nissan Maxima Service and Repair Manual: Inspection and adjustment
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description
Initialization of system should be conducted after the following conditions.
- When the sunroof motor or sunshade motor is changed.
- When the sunroof of sunshade does not operate normally (incomplete
initialization conditions).
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair
Requirement
INITIALIZATION PROCEDURE
If the sunroof or sunshade does not close or open automatically, use the
following procedure to return sunroof or sunshade operation to normal.
- Close the sunroof and sunshade, then release the sunroof switch
once.
- Press and hold the sunroof switch CLOSE (1st or 2nd) again (for
approx. 10 seconds), then sunroof will move to forward and it will be
stopped mechanically.
- Release the sunroof switch, and press and hold the sunroof switch
CLOSE (1st or 2nd) again, then sunroof and sunshade will automatically
move to fully closed⇒fully open⇒fully closed.
- Release sunroof switch, after the sunroof is fully closed.
- Check sunroof and sunshade operation.
CHECK ANTI-PINCH FUNCTION
- Full open the sunroof.
- Place a piece of wood near fully closed position.
- Close the sunroof completely with auto-slide close.
- Check that sunroof lowers for approximately 150 mm (5.91 in) or 2
seconds without pinching a piece of wood and stop.
- Full open the sunshade.
- Place a piece of wood near fully closed position.
- Close the sunshade completely with auto-slide close.
- Check that sunshade lowers for approximately 150 mm (5.91 in) or 2
seconds without pinching a piece of wood and stop.
CAUTION:
- Do not check with hands and other part of body because they
may be pinched. Do not get pinched.
- Depending on environment and driving conditions, if a similar
impact or load is applied to the sunroof it may lower.
- Check that auto-slide operates before inspection when system
initialization is performed.
- Perform initial setting when auto-slide operation or
anti-pinch function does not operate normally.
WorkFlow
DETAILED FLOW
1.OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain the malfunction information (conditions and
environment when the malfunction occurred) as much as possib ...
Other materials:
Air conditioner system refrigerant and oil recommendations
The air conditioner system in your NISSAN
vehicle must be charged with the refrigerant
HFC-134a (R-134a) and Genuine
NISSAN A/C System Oil Type ND-OIL8 or
the exact equivalents.
CAUTION
The use of any other refrigerant or oil may
cause severe damage to the air conditioning
system and may req ...
B1134 - B1137 side airbag module LH
Description
DTC B1134 - B1137 FRONT LH SIDE AIR BAG MODULE
The front LH side air bag module is wired to the air bag diagnosis sensor
unit. The air bag diagnosis sensorunit will monitor for opens and shorts in
detected lines to the front LH side air bag module.
PART LOCATION
DTC Logic
DTC DE ...
C1111 pump motor
Description
PUMP
The pump returns the brake fluid stored in the reservoir to the master
cylinder by reducing the pressure.
MOTOR
The motor drives the pump according to the signals transmitted by the ABS
actuator and electric unit (control
unit).
DTC Logic
DTC DETECTION LOGIC
DTC CON ...