Nissan Maxima Service and Repair Manual: BCM (body control module)

Reference Value

NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

  • Activate and display TPMS transmitter IDs
  • Display tire pressure reported by the TPMS transmitter
  • Read TPMS DTCs
  • Register TPMS transmitter IDs
  • Check Intelligent Key relative signal strength
  • Confirm vehicle Intelligent Key antenna signal strength

VALUES ON THE DIAGNOSIS TOOL

Nissan Maxima. VALUES ON THE DIAGNOSIS TOOL

Nissan Maxima. VALUES ON THE DIAGNOSIS TOOL

Nissan Maxima. VALUES ON THE DIAGNOSIS TOOL

Nissan Maxima. VALUES ON THE DIAGNOSIS TOOL

Nissan Maxima. VALUES ON THE DIAGNOSIS TOOL

Terminal Layout

Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Nissan Maxima. Physical Values

Fail Safe

Nissan Maxima. Fail Safe

Nissan Maxima. Fail Safe

DTC Inspection Priority Chart

If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart.

Nissan Maxima. DTC Inspection Priority Chart

Nissan Maxima. DTC Inspection Priority Chart

DTC Index

NOTE: Details of time display

  • CRNT: Displays when there is a malfunction now or after returning to the normal condition until turning ignition switch OFF → ON again.
  • - 1 - 39: Displayed if any previous malfunction is present when current condition is normal. It increases 1 → 2 → 3...38 → 39 after returning to the normal condition whenever ignition switch OFF → ON. The counter remains at 39 even if the number of cycles exceeds it. It is counted from 1 again when turning ignition switch OFF → ON after returning to the normal condition if the malfunction is detected again.

Nissan Maxima. DTC Index

Nissan Maxima. DTC Index

Nissan Maxima. DTC Index

    ECU diagnosis information
    ...

    Sunroof motor assembly
    Reference Value TERMINAL LAYOUT PHYSICAL VALUES ...

    Other materials:

    Vacuum lines
    Inspection VISUAL INSPECTION Check for improper assembly, damage and deterioration. Replace as necessary. CHECK VALVE INSPECTION Airtightness Inspection Use a suitable tool to check the built-in check valve. Replace the vacuum hose with the built-in check valve as an assembly if the vacuu ...

    Cooling fan control
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: The ECM determines the start signal status by the signals of engine speed and battery voltage. *2: This signal is sent to ECM via the CAN communication line. SYSTEM DESCRIPTION The ECM controls the cooling fan correspon ...

    Power steering fluid
    Check the fluid level in the reservoir. The fluid level should be checked when the fluid is cold at fluid temperatures of 32 to 86ºF (0 to 30ºC). The fluid level can be checked with the level gauge which is attached to the cap. To check the fluid level, remove the cap. The fluid ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2025 Copyright www.nimainfo.com
    0.0075