Door switch
BCM (body control module)System maintenance
The sensor A is located behind the lower grille
of the front bumper.
To keep the system operating properly, be sure to
observe the following:
Always keep the sensor area of the front
bumper clean.
Do not strike or damage the areas around
the sensor.
Do not cover or attach sticke ...
CAN communication circuit
Diagnosis Procedure
1.CONNECTOR INSPECTION
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect all the unit connectors on CAN communication system.
Check terminals and connectors for damage, bend and loose
connection.
2.CHECK HARNESS CON ...
Front combination lamp
Exploded View
Front combination lam
Removal and Installation
FRONT COMBINATION LAMP
Removal
Remove the front bumper fascia. Refer to EXT-16, "Removal and
Installation".
Remove the front combination lamp bolts.
Remove the harness clips from the front combination lamp assembly.
...