Nissan Maxima Service and Repair Manual: Sunroof does not operate properly

Diagnosis Procedure

1.CHECK SUNROOF MECHANISM

Check the following.

  • Operation malfunction caused by sunroof mechanism deformation, pinched harness or other foreign materials
  • Operation malfunction and interference with other parts by poor installation

2.CHECK SUNROOF MOTOR ASSEMBLY POWER SUPPLY AND GROUND CIRCUIT

Check sunroof motor assembly power supply and ground circuit

3.CHECK SUNROOF SWITCH

Check sunroof switch.

4.CONFIRM THE OPERATION

Confirm the operation again.

    Symptom diagnosis
    ...

    Sunshade system does not operate properly
    Diagnosis Procedure 1.CHECK SUNSHADE MECHANISM Check the following. Operation malfunction caused by sunshade mechanism deformation, pinched harness or other foreign materials Operation malf ...

    Other materials:

    P0715 input speed sensor A
    Description The primary speed sensor detects the primary pulley revolution speed and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", a ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver ...

    Changing wheels and tires
    Tire rotation NISSAN recommends rotating the tires every 5,000 miles (8,000 km). For additional information on tire replacing procedures, refer to "Flat tire" in the "In case of emergency" section of this manual. As soon as possible, tighten the wheel nuts to the specified torque with ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0057