Nissan Maxima Service and Repair Manual: Symptom diagnosis

Sunshade motor assembly

Wiring Diagram ...

Sunroof does not operate properly

Diagnosis Procedure 1.CHECK SUNROOF MECHANISM Check the following. Operation malfunction caused by sunroof mechanism deformation, pinched harness or other foreign materials Operation malfun ...

Other materials:

P0615 starter relay
Description  TCM controls starter relay in IPDM E/R.  TCM switches starter relay ON at "P" or "N" position and allows to crank engine.  Then it prohibits cranking other than at "P" or "N" position. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Al ...

P0720 output speed sensor
Description The secondary speed sensor detects the revolution of the CVT output shaft and emits a pulse signal. The pulse signal is transmitted to the TCM, which converts it into vehicle speed. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a s ...

Combination meter
Removal and Installation REMOVAL  Disconnect the negative battery terminal. Refer to PG-67, "Removal and Installation (Battery)".  Remove the cluster lid A. Refer to IP-16, "Removal and Installation".  Remove the combination meter screws (A) using powe ...