Nissan Maxima Service and Repair Manual: Sunshade motor assembly
Removal and Installation
REMOVAL
CAUTION:
- Before removing sunshade motor, check that glass lid is fully closed.
- After removing sunshade motor, do not attempt to rotate sunshade motor assembly as a single unit
- Close glass lid.
- Remove the headlining. Refer to INT-33, "Removal and Installation".
- Disconnect the harness connector (A) from the sunshade motor assembly.
- Remove sunroof motor assembly screws (B), then remove sunroof motor assembly (1) from sunroof unit assembly frame.
INSTALLATION
CAUTION: Before installing the sunshade motor assembly, be sure to the place the link and wire assembly in the symmetrical and fully closed position.
- Move the sunshade motor assembly laterally so that the gear is completely engaged into the wire on the sunroof unit assembly frame, and mounting surface becomes parallel.
- Install and tighten sunshade motor assembly screws.
- Connect the harness connector to the sunshade motor assembly.
- Install the headlining. Refer to INT-33, "Removal and Installation".
- Perform initilization procedure.
Sunroof motor assembly
Removal and Installation
REMOVAL
CAUTION:
Before removing sunroof motor, check that glass lid is fully
closed.
After removing sunroof motor, do not attempt to rotate sunroof
motor assemb ...
Roof link assembly
Removal and Installation
Removal
Remove the sunshade. Refer to RF-153, "Removal and Installation".
Remove the wind deflector. Refer to RF-168, "Removal and Installation".
Remove the glass lid ...
Other materials:
Vehicle security system
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
OPERATION FLOW
SETTING THE VEHICLE SECURITY SYSTEM
Initial Condition
Ignition switch is in OFF position.
Disarmed Phase
When doors or trunk is open, the vehicle
security system is set in the dis ...
Loose fuel cap warning
The LOOSE FUEL CAP warning appears in the
vehicle information display when the fuel-filler
cap is not tightened correctly after the vehicle has
been refueled. It may take a few driving trips for
the message to be displayed. To turn off the
warning, perform the following:
1. Remove and inst ...
Diagnosis and repair workflow
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1. GET INFORMATION FOR SYMPTOM
Get the detailed information from the customer about the symptom (the
condition and the environment when
the incident/malfunction occurred).
2. CHECK DTC
Check DTC.
Perform the following procedure if DTC is di ...
Nissan Maxima Owners Manual
- Illustrated table of contents
- Safety-Seats, seat belts and supplemental restraint system
- Instruments and controls
- Pre-driving checks and adjustments
- Monitor, climate, audio, phone and voice recognition systems
- Starting and driving
- In case of emergency
- Appearance and care
- Do-it-yourself
- Maintenance and schedules
- Technical and consumer information
Nissan Maxima Service and Repair Manual
0.01