Nissan Maxima Service and Repair Manual: Roof link assembly
Removal and Installation
Removal
- Remove the sunshade. Refer to RF-153, "Removal and Installation".
- Remove the wind deflector. Refer to RF-168, "Removal and Installation".
- Remove the glass lid assembly. Refer to RF-150, "Removal and
Installation".
- Remove the sunroof motor. Refer to RF-152, "Removal and Installation".
- Remove the sunshade motor. Refer to RF-153, "Removal and Installation".
- Remove the track assembly.
- Remove the 5 screws and 4 harness clips (LH).
- Remove the 5 screws (RH).
- Slide the guide link out of the channels.
Installation
Installation is in the reverse order of removal.
Removal and Installation
REMOVAL
CAUTION:
Before removing sunshade motor, check that glass lid is fully
closed.
After removing sunshade motor, do not attempt to rotate
sunshade motor ass ...
Inspection and Adjustment
INSPECTION
Wind Deflector
Open glass lid assembly fully.
Visually check for proper installation, damaged/deteriorated
components, or foreign objects within mec ...
Other materials:
Wiring diagram
HORN
Wiring Diagram
...
P1778 step motor
Description
The step motor changes the step by turning 4
coils ON/OFF according to the signal from TCM. As a result,
the flow of line pressure to primary pulley is changed and pulley ratio is
controlled.
This diagnosis item is detected when the
electrical syste ...
On board diagnostic (OBD) system
Trouble Diagnosis Introduction
CAUTION:
Do not use electrical test equipment on any circuit related to
the SRS unless instructed to do so inthis Service Manual. SRS wiring
harnesses can be identified by yellow and/or orange harness connectors.
Do not attempt to repair, splice or modify ...