Nissan Maxima Owners Manual: Extending engine run time

The remote start feature can be extended one time by performing the steps listed in "Remote starting the vehicle" in this section. Run time will be calculated as follows:

  • The first 10 minute run time will start when the remote start function is performed.
  • The second 10 minutes will start immediately when the remote start function is performed again. For example, if the engine has been running for 5 minutes, and 10 minutes are added, the engine will run for a total of 15 minutes.
  • Extending engine run time will bring you to the two remote start limit.

A maximum of two remote starts, or a single start with an extension, are allowed between ignition cycles. The ignition switch must be cycled to the ON position and then back to the OFF position before the remote start procedure can be used again.

    Remote starting the vehicle
    To use the remote start feature to start the engine perform the following: 1. Aim the Intelligent Key at the vehicle. 2. Press the LOCK button to lock all doors. 3. Within 5 seconds press ...

    Canceling a remote start
    To cancel a remote start, perform one of the following: Aim the Intelligent Key at the vehicle and press until the parking lights turn off. Turn on the hazard warning flashers. Cycle th ...

    Other materials:

    C1145, C1146 yaw rate/side/decel G sensor
    Description The yaw rate/side/decel G sensor detects the yaw rate/side/decel G affecting the vehicle, and transmits the data to the ABS actuator and electric unit (control unit) as an analog voltage signal. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSI ...

    Rear window defogger system
    System Diagram System Description Operation Description When rear window defogger switch is turned ON while ignition switch is ON, the A/C auto amp. (rear window defogger switch) transmits rear window defogger switch signal to BCM. BCM turns rear window defogger relay ON when rear ...

    DLC branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side). 2.CHECK HARNESS FOR OP ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.012