Removal and Installation

The sunroof switch (1) is an integrated part of the front room/map lamp (2), and therefore serviced as an assembly. For front room/map lamp removal and installation procedures
Sunshade
ExteriorFloor mats
WARNING
To avoid potential pedal interference that
may result in a collision, injury or death:
NEVER place a floor mat on top of another
floor mat in the driver front
position.
Use only Genuine NISSAN floor mats
specifically designed for use in your vehicle
model. For additional in ...
Condenser
Removal and Installation
REMOVAL
Remove the rear pillar finisher LH. Refer to INT-24, "Removal and
Installation".
Disconnect the harness connector, remove bolt (A), and then
remove condenser (1) from the vehicle body.
INSTALLATION
Installation is in the reverse order of ...
Tilt&telescopic switch
Removal and Installation
REMOVAL
Remove the steering column side cover (LH) (1). Refer to IP-13,
"Removal and Installation".
Release the pawls and remove tilt & telescopic switch (2) from
the steering column side cover (LH) (1).
: Pawl
INSTALLATION
Installation is in the re ...