Nissan Maxima Service and Repair Manual: Exterior

Sunroof switch

Removal and Installation The sunroof switch (1) is an integrated part of the front room/map lamp (2), and therefore serviced as an assembly. For front room/map lamp removal and installation pro ...

Precaution

PRECAUTIONS Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used alo ...

Other materials:

B2608 starter relay
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: If DTC B2608 is displ ...

Climate controlled seat
Wiring Diagram ...

Removal and Installation
REMOVAL Disconnect the battery negative terminal. Refer to PG-67, "Removal and Installation (Battery)". Disconnect the harness connector from the accelerator position sensor. Remove the three accelerator pedal nuts. Remove the accelerator pedal and accelerator position sensor assembl ...