Nissan Maxima Service and Repair Manual: Removal and installation

Periodic maintenance

SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet d ...

Front bumper

Exploded View Tow cover Engine under cover Core support cover Fog lamp cover Fog lamp (if equipped) Front bumper fascia Center support bracket Upper fascia support Front bu ...

Other materials:

P0448 evap canister vent control valve
Description The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal ...

Steering wheel
Removal and Installation REMOVAL NOTE: When removing spiral cable, use tape so that the case and rotating part keep aligned. This will prevent neutral position alignment procedure during spiral cable installation. Set steering wheel to the straight-ahead position. Remove driver air bag m ...

P1800 vias control solenoid valve 1
Description The VIAS control solenoid valve 1 cuts the intake manifold vacuum signal for power valve 1 control. It responds to ON/OFF signals from the ECM. When the solenoid is OFF, the vacuum signal from the intake manifold is cut. When the ECM sends an ON signal the coil pulls the plunger ...