Nissan Maxima Service and Repair Manual: Removal and installation

Preparation

Special Service Tools The actual shapes of the tools may differ from those illustrated here. Commercial Service Tools ...

Inside mirror

Exploded View Inside mirror Inside mirror finisher Mirror base Removal and Installation REMOVAL Remove inside mirror finisher. Remove screw of mirror base. Slide the mirror u ...

Other materials:

Evaporative emission system
System Diagram System Description *1: ECM determines the start signal status by the signals of engine speed and battery voltage. *2: This signal is sent to the ECM via the CAN communication line. SYSTEM DESCRIPTION The evaporative emission system is used to reduce hydrocarbons emitte ...

P0725 engine speed
Description The engine speed signal is transmitted from ECM to TCM via CAN communication line. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn igni ...

System maintenance
The sensor for the ICC system A is located on the front of the vehicle. To keep the ICC system operating properly, be sure to observe the following: Always keep the sensor area clean. Do not strike or damage the areas around the sensor. Do not touch or remove the screw located on ...