Bulb Specifications

*: Always check with the Parts Department for the latest parts information.
Rear combination lamp
Basic inspectionSystem description
ENGINE CONTROL SYSTEM
System Diagram
System Description
ECM performs various controls such as fuel injection control and ignition
timing control.
Component Parts Location
Intake valve timing control solenoid
valve (bank 1)
Electronic controlled engine mount
control solenoid ...
VDC/TCS/ABS
Symptom Table
If ABS warning lamp, SLIP indicator lamp turn ON, perform self-diagnosis.
NOTE:
1: The ABS does not operate when the speed is 10 km/h (6 MPH)
or less.
2: Under the following conditions, ABS is activated and
vibration is felt when brake pedal is lightly dep ...
Headlamp (LO) circuit
Description
The IPDM E/R (intelligent power distribution module engine room) controls the
headlamp low relay based on inputs from the BCM over the CAN communication
lines. When the headlamp low relay is energized, power flows through fuses 51
and 52, located in the IPDM E/R. Power then flows ...