Nissan Maxima Service and Repair Manual: ECU diagnosis information

Hazard switch

Component Function Check 1.CHECK HAZARD SWITCH SIGNAL BY CONSULT CONSULT DATA MONITOR Turn ignition switch ON. Select "HAZARD SW" of BCM (FLASHER) DATA MONITOR item. With operating the hazar ...

BCM (body control module)

Reference Value NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display ...

Other materials:

U1000 CAN comm circuit
Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each co ...

P0448 evap canister vent control valve
Description The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal ...

IPDM E/R (intelligent power distribution module engine room)
Reference Value VALUES ON THE DIAGNOSIS TOOL TERMINAL LAYOUT PHYSICAL VALUES Fail Safe CAN COMMUNICATION CONTROL When CAN communication with ECM and BCM is impossible, IPDM E/R performs fail-safe control. After CAN communication recovers normally, it also returns to nor ...