Preparation
Headlamp aiming adjustmentInstalling front license plate
Use the following steps to mount the front license
plate:
1. Make holes on the plastic finisher at the
location mark (small dimple) using a 5 mm
(0.20 in) drill. Apply light pressure to the drill.
Install the license plate holder using the two
screws provided with the holder.
2. Mount ...
Trunk lamp switch
Description
Detects trunk open/close condition.
Component Function Check
1. CHECK FUNCTION
With CONSULT
Check TRNK/HAT MNTR in Data Monitor mode with CONSULT.
Diagnosis Procedure
1. CHECK TRUNK LAMP SWITCH INPUT SIGNAL
Turn ignit ...
Intake Manifold Collector
Removal and Installation
Intake manifold collector
Intake manifold collector gasket
Electric throttle control actuator gasket
Electric throttle control actuator
Refer to INSTALLATION
Refer to INSTALLATION
WARNING: To avoid the danger of being
scalded, do not drain the coolan ...