Nissan Maxima Service and Repair Manual: Wiring diagram

ECU diagnosis information

BCM (BODY CONTROL MODULE) Reference Value NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional informatio ...

Interior room lamp

Wiring Diagram ...

Other materials:

P2135 TP sensor
Description Electric throttle control actuator consists of throttle control motor, throttle position sensor, etc. The throttle position sensor responds to the throttle valve movement. The throttle position sensor has two sensors. These sensors are a kind of potentiometers which transform ...

Low tire pressure warning lamp blinks
Low Tire Pressure Warning Lamp Flashes When Ignition Switch Is Turned On NOTE: If low tire pressure warning lamp flashes as shown, the system is normal. Flash Mode A  This mode shows transmitter status is OFF-mode.Carry out transmitter wake up operation. DIAGNOSTIC PROCEDURE ...

Antenna AMP 
Removal and Installation  REMOVAL Remove the rear pillar finisher RH. Refer to INT-27, "Exploded View". Detach the antenna amp. harness clip (A). Disconnect the harness connectors (B) from the antenna amp. (1). Remove the antenna amp. screw (C) and the antenna amp. (1).  ...