Nissan Maxima Service and Repair Manual: Front wiper motor ground circuit

Front wiper auto stop signal circuit

Component Function Check 1. CHECK FRONT WIPER (AUTO STOP) OPERATION CONSULT DATA MONITOR Select "WIP AUTO STOP" of IPDM E/R DATA MONITOR item. Operate the front wiper. With the front wiper o ...

Washer switch

Description Washer switch is integrated with combination switch (wiper and washer switch). Combination switch (wiper and washer switch) supplies ground and fuse # 38 from the IPEM E/R supp ...

Other materials:

Freeing a frozen door lock
To prevent a door lock from freezing, apply deicer through the key hole. If the lock becomes frozen, heat the key before inserting it into the key hole or use the remote keyless entry function on the Intelligent Key. Antifreeze In the winter when it is anticipated that the temperature will dr ...

System maintenance
The sensor A is located behind the lower grille of the front bumper. To keep the system operating properly, be sure to observe the following: Always keep the sensor area of the front bumper clean. Do not strike or damage the areas around the sensor. Do not cover or attach st ...

P1777 step motor
Description The step motor changes the step by turning 4 coils ON/OFF according to the signal from TCM. As a result, the flow of line pressure to primary pulley is changed and pulley ratio is controlled. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive ve ...