Nissan Maxima Service and Repair Manual: Service data and specifications (SDS)

Front wiper and washer switch

Removal and Installation NOTE:The front wiper and washer switch is part of the combination switch assembly. REMOVAL Disconnect battery. CAUTION: Before servicing, disconnect both batter ...

Defogger

...

Other materials:

P0506 ISC system
Description The ECM controls the engine idle speed to a specified level via the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine id ...

Steering knuckle
Removal and Installation Steering knuckle Splash guard Wheel hub and bearing Cotter pin REMOVAL Remove the front wheel hub and bearing. Refer to FAX-7, "Removal and Installation". Remove the steering linkage from the steering knuckle. Refer to ST-26, "Removal and Insta ...

P0137, P0157 HO2S2
Description The heated oxygen sensor 2, after three way catalyst (manifold), monitors the oxygen level in the exhaust gas on each bank. Even if switching characteristics of the air fuel ratio (A/F) sensor 1 are shifted, the air-fuel ratio is controlled to stoichiometric, by the signal ...