Nissan Maxima Service and Repair Manual: Removal and installation

  • Filament
  • Inspection and Repair INSPECTION When measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger. Attach probe circuit tester (in Volt range) to middle portion of each filament. If a filament is burned out, circuit tester registers zero or battery voltage. To locate burned out point, move probe to left and right along filament. Test needle will swing abruptly when probe passes the point REPAIR REPAIR EQUIPMENT Conductive silver composition (Dupont No. 4817 or equivalent) Ruler 30 cm (11.

  • Condenser
  • Removal and Installation REMOVAL Remove the rear pillar finisher LH. Refer to INT-24, "Removal and Installation". Disconnect the harness connector, remove bolt (A), and then remove condenser (1) from the vehicle body. INSTALLATION Installation is in the reverse order of removal.

Preparation

Filament