Nissan Maxima Service and Repair Manual: Condenser

Removal and Installation

REMOVAL

Nissan Maxima. REMOVAL

  1. Remove the rear pillar finisher LH. Refer to INT-24, "Removal and Installation".
  2. Disconnect the harness connector, remove bolt (A), and then remove condenser (1) from the vehicle body.

INSTALLATION

Installation is in the reverse order of removal.

    Filament
    Inspection and Repair INSPECTION When measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger. Attach probe ci ...

    Horn
    ...

    Other materials:

    Precaution
    PRECAUTIONS Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to ...

    Outside mirrors
    The outside mirror remote control will operate only when the ignition switch is in the ACC or ON position. Move the small switch 1 to select the right or left mirror. Adjust each mirror to the desired position using the large switch 2 . WARNING Objects viewed in the outside mirror on ...

    TPMS malfunction
    If the TPMS is not functioning properly, the low tire pressure warning light will flash for approximately 1 minute when the ignition switch is placed in the ON position. The light will remain on after 1 minute. Have the system checked. It is recommended that you visit a NISSAN dealer for this ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.025