Nissan Maxima Service and Repair Manual: Horn

Condenser

Removal and Installation REMOVAL Remove the rear pillar finisher LH. Refer to INT-24, "Removal and Installation". Disconnect the harness connector, remove bolt (A), and then r ...

Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELTPRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used alongwith ...

Other materials:

Power supply and ground circuit
BCM BCM : Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuses or fusible link are blown. 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF. Disconnect BCM. Check voltage between BCM harness connector and ground. 3. CHECK GROUND CIRCUIT Che ...

Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any custome ...

Power control system
System Diagram System Description COOLING FAN CONTROL IPDM E/R controls cooling fans according to the status of the cooling fan speed request signal received from ECM via CAN communication. GENERATOR CONTROL IPDM E/R outputs power generation command signal (PWM signal) to the generat ...