Nissan Maxima Service and Repair Manual: U1010 control unit (CAN)

DTC U1000 CAN communication

DTC Logic DTC DETECTION LOGIC Diagnosis Procedure Symptom: Displays "CAN COMM CIRC [U1000]" as a self-diagnosis result of combination meter. 1.CHECK CAN COMMUNICATION Select "SELF-DIAG RESULT ...

DTC B2205 vehicle speed circuit

Description The ABS actuator and electric unit (control unit) provides a vehicle speed signal to the combination meter via CAN communication lines. DTC Logic Diagnosis Procedure Symptom: Dis ...

Other materials:

P0127 IAT sensor
Description The intake air temperature sensor is built-into the mass air flow sensor (1). The sensor detects intake air temperature and transmits a signal to the ECM. The temperature sensing unit uses a thermistor which is sensitive to the change in temperature. Electrical resistance o ...

Parking lamp circuit
Description The IPDM E/R (intelligent power distribution module engine room) controls the tail lamp relay based on inputs from the BCM over the CAN communication lines. When the tail lamp relay is energized, power flows through fuses 46 and 47, located in the IPDM E/R. Power then flows to the ...

P0845 transmission fluid pressure SEN/SW B
Description The primary pressure sensor detects primary pressure of CVT and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 ...