Nissan Maxima Service and Repair Manual: DTC B2205 vehicle speed circuit

Description

The ABS actuator and electric unit (control unit) provides a vehicle speed signal to the combination meter via CAN communication lines.

DTC Logic

Diagnosis Procedure

Symptom: Displays "VEHICLE SPEED CIRC [B2205]" as a self-diagnosis result of combination meter.

1.CHECK COMBINATION METER INPUT SIGNAL

  1. Start engine and select "METER/M&A" on CONSULT.
  2. Using "SPEED METER" on "DATA MONITOR", compare the value of DATA MONITOR with speedometer pointer of combination meter. Speedometer and DATA MONITOR indications should be close.
    U1010 control unit (CAN)
    Description Initial diagnosis of combination meter. DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.REPLACE COMBINATION METER When DTC "U1010" is detected, replace combination meter. Refer ...

    B2267 engine speed
    Description The engine speed signal is transmitted from ECM to the combination meter via CAN communication. DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS OF ECM ...

    Other materials:

    Bose speaker AMP
    Removal and Installation Bose speaker amp. Screws REMOVAL NOTE: If removing the BOSE speaker amp. bracket, it is necessary to remove the parcel shelf finisher. The BOSE speaker amp. can be removed without removing the BOSE speaker amp. bracket. Disconnect the battery negativ ...

    Wiring diagram
    IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM) Wiring Diagram ...

    Wind deflector
    Removal and Installation REMOVAL Open the glass lid. Remove the side screw (A) to release the wind deflector side arms (1). : Front Disconnect and release the inner blind (1) slide clip from wind deflector. : Front Remove the front screws (A), then remove wind deflector ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0087