Nissan Maxima Service and Repair Manual: ECU diagnosis information

Microphone signal circuit

Description Voice signals are transmitted from the microphone to the Bluetooth control unit using the microphone signal circuits. Diagnosis Procedure 1.CHECK HARNESS BETWEEN BLUETOOTH CONTROL UNI ...

Audio unit

Reference Value TERMINAL LAYOUT PHYSICAL VALUES ...

Other materials:

System operation
The automatic drive positioner system will not work or will stop operating under the following conditions: When the vehicle speed is above 0 mph (0 km/h) or 4 mph (7km/h) for some limited functions such as linking a key fob to the meter when the power source is turned on from off or du ...

Antenna AMP 
Removal and Installation  REMOVAL Remove the rear pillar finisher RH. Refer to INT-27, "Exploded View". Detach the antenna amp. harness clip (A). Disconnect the harness connectors (B) from the antenna amp. (1). Remove the antenna amp. screw (C) and the antenna amp. (1).  ...

Main line between DLC and HVAC circuit
Diagnosis Procedure 1.CHECK HARNESS CONTINUITY (OPEN CIRCUIT) Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Disconnect the following harness connectors. ECM A/C auto amp. Check the continuity between the data link connector and the A/C ...