Description
Initial diagnosis of AV control unit.
DTC Logic
DTC DETECTION LOGIC

Diagnosis Procedure
1.REPLACE AV CONTROL UNIT
hen DTC U1010 is detected, replace AV control unit
U1000 CAN comm circuit
U1200 AV control unitSwitch operation
Type A (if so equipped)
The windshield wiper and washer operates when
the ignition switch is placed in the ON position.
Push the lever down to operate the wiper at the
following speed:
Intermittent (INT) or (AUTO) - intermittent
operation can be adjusted by turning the
knob A .
L ...
Magnet clutch
Description
SYSTEM DESCRIPTION
A/C auto amp. controls A/C compressor operation by ambient temperature and
signal from ECM.
Low Temperature Protection Control
A/C auto amp. will turn the A/C compressor ON or OFF as determined
by a signal detected by ambient sensor.
When ambient temperatur ...
B2128 UART communication line
Description
Driver seat control unit performs UART communication with the automatic drive
positioner control unit using 1 communication line. Driver seat control unit
receives the operation signals of ADP steering switch, door mirror remote
control switch and the position signals of tilt sens ...