Nissan Maxima Service and Repair Manual: U1200 AV control unit

U1010 control unit (CAN)

Description Initial diagnosis of AV control unit. DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.REPLACE AV CONTROL UNIT hen DTC U1010 is detected, replace AV control unit ...

U1216 AV control unit

Description Replace the AV control unit if this DTC is displayed. Part name  Description  AV CONTROL UNIT  It is the master unit of the MULTI AV system ...

Other materials:

System maintenance
The sensor for the ICC system A is located on the front of the vehicle. To keep the ICC system operating properly, be sure to observe the following: Always keep the sensor area clean. Do not strike or damage the areas around the sensor. Do not touch or remove the screw located on ...

Steering gear and linkage
Exploded View Cotter pin Steering gear assembly Front Removal and Installation NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling. REMOVAL Remove front wheel and tire using power tool. Refer to WT-60, "Adjus ...

Power supply and ground circuit
AUDIO UNIT AUDIO UNIT : Diagnosis Procedure 1.CHECK FUSES 2.POWER SUPPLY CIRCUIT CHECK Disconnect audio unit connector M132. Check voltage between the audio unit connector M132 and ground. 3.GROUND CIRCUIT CHECK Inspect audio unit case ground. DISPLAY UNIT DISPLAY UNIT : Dia ...