Nissan Maxima Service and Repair Manual: U1232 steering angle sensor

DTC Logic

Nissan Maxima. DTC Logic

Diagnosis Procedure

ADJUST THE PREDICTIVE COURSE LINE CENTER POSITION OF THE STEERING ANGLE SENSOR

When U1232 is detected, adjust the predictive course line center position of the steering angle sensor.

    U122A AV control unit
    DTC Logic Diagnosis Procedure 1.PERFORM THE SELF-DIAGNOSIS When U122A is detected, write configuration data with "MULTI AV" of CONSULT. U122E AV CONTROL UNIT DTC Logic DTC DETECTION LOGIC ...

    U1243 display unit
    Description Part name  Description  DISPLAY UNIT  Display image is controlled by the serial communication from AV control unit. Inputs the RGB i ...

    Other materials:

    BCM (body control module)
    Reference Value NOTE:The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech IIUser Guide for additional information. Activate and display TPMS transmitter IDs Display tire pressure reported by the TPMS transmitter Read TPMS DTCs Regi ...

    B2630, B2631 sunload sensor
    Description COMPONENT DESCRIPTION Sunload Sensor The sunload sensor (1) is located on the driver side defroster grille. It detects sunload entering through windshield by means of a photo diode. The sensor converts the sunload into a current value, which is then input into the A/C auto ...

    TPMS malfunction
    If the TPMS is not functioning properly, the low tire pressure warning light will flash for approximately 1 minute when the ignition switch is placed in the ON position. The light will remain on after 1 minute. Have the system checked. It is recommended that you visit a NISSAN dealer for this ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2025 Copyright www.nimainfo.com
    0.0152