Nissan Maxima Service and Repair Manual: Center speaker

Removal and Installation

REMOVAL

  1. Remove the center speaker grille, using a suitable tool.
  2. Remove the center speaker screws (A).
  3. Pull out the center speaker (1), disconnect the harness connector from the center speaker and remove.

Nissan Maxima. CENTER SPEAKER

INSTALLATION

Installation is in the reverse order of removal.

    Front tweeter
    Removal and Installation REMOVAL Remove the front pillar finisher. Refer to INT-24, "Removal and Installation". Remove the front tweeter speaker grille. Refer to IP-10, "Explo ...

    Front door speaker
    Removal and Installation REMOVAL Remove the front door finisher. Refer to INT-18, "Removal and Installation". Remove the front door speaker screws (A). Disconnect the harness con ...

    Other materials:

    P0452 evap control system pressure sensor
    Description The EVAP control system pressure sensor detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously ...

    RGB (R: red) signal circuit
    Description Transmit the image displayed with AV control unit with RGB signal to the display unit. Diagnosis Procedure 1.CHECK CONTINUITY RGB (R: RED) SIGNAL CIRCUIT Turn ignition switch OFF. Disconnect display unit connector M141 and AV control unit connector M117. Check continu ...

    Hazard switch
    Component Function Check 1.CHECK HAZARD SWITCH SIGNAL BY CONSULT CONSULT DATA MONITOR Turn ignition switch ON. Select "HAZARD SW" of BCM (FLASHER) DATA MONITOR item. With operating the hazard switch, check the monitor status.   Diagnosis Procedure 1.CHECK HAZARD SWITCH SIGNAL I ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0094