Nissan Maxima Service and Repair Manual: Aux in jack

USB connector

Removal and Installation REMOVAL Remove the center console assembly. Refer to IP-14, "Removal and Installation". Push the pawl from the back of the center console to remove the ...

Front tweeter

Removal and Installation REMOVAL Remove the front pillar finisher. Refer to INT-24, "Removal and Installation". Remove the front tweeter speaker grille. Refer to IP-10, "E ...

Other materials:

Power supply and ground circuit
BCM BCM : Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuses or fusible link are blown. 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF. Disconnect BCM. Check voltage between BCM harness connector and ground. 3. CHECK GROUND CIRCUIT Che ...

Microphone signal circuit
Description Voice signals are transmitted from the microphone to the AV control unit using the microphone signal circuits. Diagnosis Procedure 1.CHECK HARNESS BETWEEN AV CONTROL UNIT AND MICROPHONE Turn ignition switch OFF. Disconnect AV control unit connector and microphone connector ...

Crash zone sensor
Component Crash zone sensor harness connector Crash zone sensor Nut Front Removal and Installation CAUTION: Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 minutes. Do not use air tools or electric tools for servicing. ...