
Perform the following steps to enable or disable the Driver Attention Alert system.
1. Press the
button until
"Settings" displays
in the vehicle information display and
press the OK button. Use the
button
to select "Driver Assistance". Then press the
OK button.
2. Select "Driver Attention Alert" and press the OK button.
NOTE:
The setting will be retained even if the engine is restarted.
Driver Attention Alert system operation
Driver Attention Alert system limitationsB2192 ID discord, IMMU-ECM
Description
BCM performs the ID verification with ECM that allows the
engine to start. Start the engine if the ID is OK.
ECM prevents the engine from starting if the ID is not registered. BCM starts
the communication with ECM if
ignition switch is turned ON.
DTC Logic
DTC DETECTION LOGIC ...
Antenna AMP
Removal and Installation
REMOVAL
Remove the rear pillar finisher RH. Refer to INT-23, "Exploded
View".
Detach the antenna amp. harness clip (A).
Disconnect the harness connectors (B) from the antenna amp.
(1).
Remove the antenna amp. screw (C) and the antenna amp. (1).
INSTALLAT ...
Diagnosis system (AV control unit)
Description
The AV control unit diagnosis function starts up with multifunction
switch operation and the AV control unit
performs a diagnosis for each unit in the system during the on board
diagnosis.
Perform a CONSULT diagnosis if the on board diagnosis does not start,
e.g., the s ...