Nissan Maxima Owners Manual: Driver Attention Alert (if so equipped)

Nissan Maxima Owners Manual / Starting and driving / Driver Attention Alert (if so equipped)

WARNING

Failure to follow the warnings and instructions for proper use of the Driver Attention Alert system could result in serious injury or death.

The Driver Attention Alert system is only a warning to inform the driver of a potential lack of driver attention or drowsiness. It will not steer the vehicle or prevent loss of control.

The Driver Attention Alert system does not detect and provide an alert of the driver's lack of attention or fatigue in every situation.

It is the driver's responsibility to:

  • stay alert,
  • drive safely,
  • keep the vehicle in the traveling lane,
  • be in control of the vehicle at all times,
  • avoid driving when tired,
  • avoid distractions (texting, etc).

The Driver Attention Alert system helps alert the driver if the system detects a lack of attention or driving fatigue.

The system monitors driving style and steering behavior over a period of time, and it detects changes from the normal pattern. If the system detects that driver attention is decreasing over a period of time, the system uses audible and visual warnings to suggest that the driver take a break.

System maintenance
The sensor A is located behind the lower grille of the front bumper. To keep the system operating properly, be sure to observe the following: Always keep the sensor area of the front ...

Driver Attention Alert system operation
If the system detects driver fatigue or that driver attention is decreasing, the message "Take a break?"appears in the vehicle information display and a chime sounds when the vehicle is driven ...

Other materials:

Parking brake control
Exploded View Parking brake pedal Parking brake switch Pedal pad Adjusting nut Lock plate Front cable Rear cable (RH) Rear cable (LH) Equalizer Spring Pin   Front Removal and Installation REMOVAL Remove rear wheel and tire using power tool. Refer to ...

B2553 ignition relay
Description BCM turns ON the following relays to ignition power supply to each ECU when the ignition switch is turned ON. Ignition relay-1 (inside IPDM E/R) Ignition relay-2 (inside fuse block (J/B)) Front blower motor relay BCM checks any ignition relay ON request for consistency wi ...

P1723 speed sensor
Description The secondary speed sensor detects the revolution of parking gear and generates a pulse signal. The pulse signal is sent to the TCM, which converts it into vehicle speed. The primary speed sensor detects the primary pulley revolution speed and sends a signal to the TCM. DTC Lo ...

Nissan Maxima Owners Manual

Nissan Maxima Service and Repair Manual

© 2017-2026 Copyright www.nimainfo.com
0.016