Nissan Maxima Owners Manual: Cleaning

If your windshield is not clear after using the windshield-washer or if a wiper blade chatters when running, wax or other material may be on the blade or windshield.

Clean the outside of the windshield with a washer solution or a mild detergent. Your windshield is clean if beads do not form when rinsing with clear water.

Clean each blade by wiping it with a cloth soaked in a washer solution or a mild detergent. Then rinse the blades with clear water. If your windshield is still not clear after cleaning the blades and using the wiper, replace the blades.

CAUTION

Worn windshield wiper blades can damage the windshield and impair driver vision.

    Windshield wiper blades
    ...

    Replacing
    Replace the wiper blades if they are worn. To replace the windshield wiper blades, follow the procedure below: 1. Lift the wiper arm away from the windshield. 2. Push the release tab B . ...

    Other materials:

    Subwoofer
    Removal and Installation Subwoofer (LH) Subwoofer (RH)  Subwoofer screws Subwoofer connectors REMOVAL Remove the rear parcel shelf finisher. Refer to INT-28, "Removal and Installation". Remove the subwoofer screws. Pull out the subwoofer, disconnect the harness con ...

    AV branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the AV control unit for damage, bend and loose connection (unit side and connector side). 2.CHECK HARNESS FOR OPEN CIRC ...

    B26e1 no reception of engine status signal
    Description BCM receives the engine status signal from ECM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: If DTC B26E1 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-29, "DTC Logic". If DTC B26E1 is displayed with D ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0112