Nissan Maxima Owners Manual: Chassis & body maintenance

Abbreviations: I = Inspect and correct or replace as necessary, R = Replace,

Nissan Maxima. Chassis & body maintenance

Nissan Maxima. Chassis & body maintenance

NOTE:

Maintenance items with " " should be performed more frequently according to "Maintenance under severe driving conditions".

(1) If towing a trailer, using a camper or a car-top carrier or driving on rough or muddy roads, inspect CVT fluid deterioration at NISSAN dealers every 60,000 miles (96,000 km), then change CVT fluid if necessary. And if the inspection is not performed, change (not just inspect) CVT fluid every 60,000 miles (96,000 km).

(2) Refer to "Tire rotation" under the "General Maintenance" heading earlier in this section.

    Emission control system maintenance
    Abbreviations: I = Inspect and correct or replace as necessary, R = Replace, D = Drain water NOTE: (1) After 40,000 miles (64,000 km) or 48 months, inspect every 10,000 miles (16,000 km) ...

    Maintenance under severe operating conditions
    Severe driving conditions The maintenance intervals shown on the preceding pages are for normal operating conditions. If the vehicle is mainly operated under severe driving conditions as shown bel ...

    Other materials:

    Vehicle security system
    Your vehicle has two types of security systems: Vehicle security system NISSAN Vehicle Immobilizer System The vehicle security system provides visual and audible alarm signals if someone opens the doors, trunk, or hood when the system is armed. It is not, however, a motion detection ...

    B1150 - B1153 side curtain air bag module LH
    Description DTC B1150 - B1153 LH SIDE CURTAIN AIR BAG MODULE The LH side curtain air bag module is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensorunit will monitor for opens and shorts in detected lines to the LH side curtain air bag module. PART LOCATION DTC Logic ...

    Diagnosis system (BCM)
    CONSULT Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions. CONSULT Function (BCM - AIR PRESSURE MONITOR) NOTE: The Signal Tech II Tool (J-50190) can be used to ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0076