When traveling or registering in another country
Vehicle identification number (VIN) plateU1010 control unit (CAN)
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1. REPLACE BCM
When DTC [U1010] is detected, replace BCM.
Special Repair Requirement
1. REQUIRED WORK WHEN REPLACING BCM
Initialize NVIS by CONSULT. For the details of initialization refer to
CONSULT Immobilizer mode and follow
the on ...
Fog lights
Replacing the fog light bulb
If fog light bulb replacement is required, it is
recommended that you visit a NISSAN dealer for
this service.
CAUTION
High pressure halogen gas is sealed
inside the halogen bulb. The bulb may
break if the glass envelope is scratched
or the bulb is dropped.
...
Ignition signal
Description
The ignition signal from the ECM is sent to and amplified by the power
transistor. The power transistor turns
ON and OFF the ignition coil primary circuit. This ON/OFF operation induces the
proper high voltage in the coil
secondary circuit.
Component Function Check
1.INSPECTIO ...