Nissan Maxima Owners Manual: Emission control information label

Vehicle identification number (VIN) plate

The vehicle identification number (VIN) plate is attached as shown. This number is the identification for your vehicle and is used in the vehicle registration. Vehicle identification number (c ...

Installing front license plate

Use the following steps to mount the front license plate: 1. Make holes on the plastic finisher at the location mark (small dimple) using a 5 mm (0.20 in) drill. Apply light pressure to the dr ...

Other materials:

P1611 ID discord, IMMU-ECM
Description BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered. BCM starts the communication with ECM if ignition switch is turned ON. DTC Logic DTC DETECTION LOGIC ...

Low tire pressure warning lamp blinks
Low Tire Pressure Warning Lamp Flashes When Ignition Switch Is Turned On NOTE: If low tire pressure warning lamp flashes as shown, the system is normal. Flash Mode A  This mode shows transmitter status is OFF-mode.Carry out transmitter wake up operation. DIAGNOSTIC PROCEDURE ...

Trunk room lamp circuit
Description Controls the trunk room lamp (ground side) to turn the trunk room lamp ON and OFF. Component Function Check CAUTION: Before performing the diagnosis, check that the following is normal. Battery saver output/power supply Trunk room lamp bulb 1.CHECK TRUNK ROOM LAMP OPERATI ...