Nissan Maxima Service and Repair Manual: Service data and specifications (SDS)

Oil cooler

Removal and Installation Oil filter Oil cooler bolt  Water pipe  Water hose  Oil cooler  O-ring  Oil pan  Water pipe  Relief valve &nbs ...

Engine cooling system

...

Other materials:

B26e1 no reception of engine status signal
Description BCM receives the engine status signal from ECM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: If DTC B26E1 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-29, "DTC Logic". If DTC B26E1 is displayed with D ...

Fuel pump
Description *: ECM determines the start signal status by the signals of engine speed and battery voltage. The ECM activates the fuel pump for several seconds after the ignition switch is turned ON to improve engine start ability. If the ECM receives a engine speed signal from the camsh ...

Disk eject signal circuit
Description The eject signal is output to AV control unit when the eject switch of A/C and AV switch assembly is pressed. Diagnosis Procedure 1.CHECK CONTINUITY DISK EJECT SIGNAL CIRCUIT Turn ignition switch OFF. Disconnect A/C and AV switch assembly connector M98 and AV control un ...