Nissan Maxima Owners Manual: Warning lights
For additional information on warnings and indicators, refer to "Vehicle information display" in this section.
Anti-lock Braking
System (ABS)
warning light
When the ignition switch is placed in the ON position, the ABS warning light illuminates and then turns off. This indicates the ABS is operational.
If the ABS warning light illuminates while the engine is running or while driving, it may indicate the ABS is not functioning properly. Have the system checked. It is recommended that you visit a NISSAN dealer for this service.
If an ABS malfunction occurs, the anti-lock function is turned off. The brake system then operates normally but without anti-lock assistance. For additional information, refer to "Brake system" in the "Starting and driving" section of this manual.
Brake warning light (parking
brake)
This light functions for the foot brake systems.
Parking brake indicator
When the ignition switch is placed in the ON position, this light comes on when the parking brake is applied.
Brake warning light
This light illuminates if there is a problem with the foot brake systems.
- Low brake fluid warning light
- Anti-lock Braking System (ABS) warning indicator
- Low tire pressure warning
- TPMS malfunction
Checking lights
Anti-lock Braking System (ABS)
warning light
Brake warning light (parking brake)
Brake warning light
Charge warning light
Engine oil p ...
Low brake fluid warning light
When the ignition switch is placed in the ON
position, the light warns of a low brake fluid level.
If the light comes on while the engine is running,
with the parking brake not applied, stop the ...
Other materials:
B2098 ignition relay on stuck
DTC Logic
DTC DETECTION LOGIC
1.PERFORM DTC CONFIRMATION PROCEDURE
Turn the power supply position to start under the following
conditions and wait for at least 1 second.
CVT selector lever is in the P (Park) or N (Neutral) position.
Depress the brake pedal
Check "Self-diag ...
Warning function symptoms
Symptom Table
WARNING FUNCTION MALFUNCTION
NOTE:
Before performing the diagnosis in the following table, check
"WORK FLOW". Refer to DLK-9, "Work Flow".
Check that vehicle is under the condition shown in "Conditions
of vehicle" before starting diagnosis, and
check each sy ...
Unlock sensor
Description
Detects door lock condition of driver door.
Component Function Check
1. CHECK FUNCTION
With CONSULT
Check unlock sensor UNLK SEN−DR in "Data Monitor" mode.
Diagnosis Procedure
1. CHECK UNLOCK SENSOR POWER SUPPLY
Check signal between BCM connector and ground with o ...
Nissan Maxima Owners Manual
- Illustrated table of contents
- Safety-Seats, seat belts and supplemental restraint system
- Instruments and controls
- Pre-driving checks and adjustments
- Monitor, climate, audio, phone and voice recognition systems
- Starting and driving
- In case of emergency
- Appearance and care
- Do-it-yourself
- Maintenance and schedules
- Technical and consumer information
Nissan Maxima Service and Repair Manual
0.008