Nissan Maxima Owners Manual: Wiper and washer switch

NISSAN vehicle immobilizer system

The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of a registered key. If the engine fails to start using a registered key (for example, when interference ...

Switch operation

Type A (if so equipped) The windshield wiper and washer operates when the ignition switch is placed in the ON position. Push the lever down to operate the wiper at the following speed: I ...

Other materials:

Sunload sensor
Removal and Installation REMOVAL Remove the front LH speaker grille from the instrument panel. Refer to IP-10, "Exploded View". Disconnect the harness connector from the sunload sensor. Release the sunload sensor tabs and remove the sunload sensor (1) from the front LH speake ...

Parking lamp circuit
Description The IPDM E/R (intelligent power distribution module engine room) controls the tail lamp relay based on inputs from the BCM over the CAN communication lines. When the tail lamp relay is energized, power flows through fuses 46 and 47, located in the IPDM E/R. Power then flows to the ...

CAN communication system
System Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto each vehicle, a ...