Rear window and outside mirror (if so equipped) defroster switch
Headlight control switchCondenser
Removal and Installation
REMOVAL
Remove the rear pillar finisher LH. Refer to INT-24, "Removal and
Installation".
Disconnect the harness connector, remove bolt (A), and then
remove condenser (1) from the vehicle body.
INSTALLATION
Installation is in the reverse order of ...
Emission control system maintenance
Abbreviations: I = Inspect and correct or replace as necessary, R =
Replace, D = Drain water
NOTE:
(1) After 40,000 miles (64,000 km) or 48 months, inspect every 10,000
miles (16,000 km) or 12 months. Replace the drive belts if found
damaged.
(2) If operating mainly in dusty condit ...
Power supply and ground circuit
BCM (BODY CONTROL MODULE)
BCM (BODY CONTROL MODULE) : Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuses or fusible link are blown.
2. CHECK POWER SUPPLY CIRCUIT
Turn ignition switch OFF.
Disconnect BCM.
Check voltage between BCM harness connector and ...