
Turn signal
Lane change signal
Move the lever up or down until the turn signal begins to flash, but the lever does not latch, and release the lever. The turn signal will automatically flash three times.
Choose the appropriate method to signal a lane change based on road and traffic conditions.
NOTE:
The 3 flash pass feature can be disabled.
For additional information, refer to "Vehicle information display" in this section.
Daytime running light system
Fog light switchUnit disassembly and assembly
FRONT DRIVE SHAFT
Disassembly and Assembly (LH)
Circlip
Dust shield
Housing
Snap ring
Spider assembly
Stopper ring
Boot band
Boot
Shaft
Damper band
Dynamic damper
Circlip
. Joint sub-assembly : Wheel side
: Fill us ...
Drive belt
VQ35DE engine
1. Crankshaft pulley
2. Drive belt automatic tensioner pulley
3. Generator pulley
4. Air conditioner compressor pulley
WARNING
Be sure the ignition switch is placed in the
OFF or LOCK position before servicing
drive belt. The engine could rotate
unexpectedly.
1. Visually ...
System description
FRONT WIPER AND WASHER SYSTEM
System Diagram
System Description
OUTLINE
The front wiper is controlled by each function of BCM and IPDM E/R.
Control by BCM
Combination switch reading function
Front wiper control function
Control by IPDM E/R
Front wiper control function
Relay con ...